TechniSat DIGICLOCK 1 Manual page 22

achieve the best FM radio reception.
5.2 Auto scan
> To initiate automatic radio station search, press and hold the FM Radio button
for 3 seconds.
> The device will automatically search and save radio stations. During scanning,
the display shows the number of found radio stations."
The unit uses the AUTO SEARCH function during auto search, which
automatically saves the first 20 strong FM stations found to the favorites list.
The first strong radio stations found will be saved in presets, starting with 1
and ending with 20.
After the scanning is complete, the up
change favorite programs (P01-P20).
For the best FM reception, fully extend the wire antenna. Avoid proximity to
speakers or other electrical devices.
5.3 Recal a saved channel
> To recall previously saved stations, press the up
individually or select the appropriate program number (P01 - P20).
The number of programs available on the favorites list depends on the
reception quality.
6 Alarm function
The radio receiver allows you to set two alarms at pre-determined times. It can
function as an alarm clock or play a radio station.
6.1 Alarm settings
Setting and deactivating the alarm can only be done in standby mode.
> Please switch the device to standby mode by turning it off with the
FM Radio button.
> To start setting the alarm, press the ALARM button.
> Next, use the
> Please press the ALARM button to confirm the hour setting.
> Then next, use the
> Press the ALARM button to confirm and enter the alarm sound settings.
> Using the
22
and buttons to set the hour.
and
and buttons , please select the type of alarm.
or down
buttons to set the minutes.
button will be used to
or down buttons