TechniSat DIGICLOCK 1 Manual page 21

4 Time setting
To ensure the clock works correctly, it should be set before the first use. After turning
on the radio's power, the LCD display is in clock display mode and shows 0:00.
To access the time settings, the radio receiver should be in standby mode.
While playing FM, there is no possibility to change the displayed time.
To access the time settings, please:
> Turn off the radio by pressing the FM Radio button.
> The radio is now in standby mode. The current time is displayed on the
screen.
> Please press the TIME button to begin changing the time.
> Next use the buttons
> Proszę wcisnąć przycisk TIME aby potwierdzić wybór.
> Next use the buttons
Pressing the TIME button again will confirm the selection and end the time-
>
setting process.
If there is no activity for about 10 seconds, the device will return to
displaying the time (standby mode).
The saved time settings are lost in case of power loss.
5 FM reception
> To ensure good FM reception, please fully extend the wire antenna located at
the back of the device. Press the FM Radio button.
> The radio is now in FM playback mode.
5.1 Manual scan
> Using the up
> Holding down the up
scanning will stop the scanning at the current frequency.
If the reception is too weak and there is noise on the received station, try
improving reception by adjusting the position of the telescopic antenna
To ensure maximum FM tuner reception, fully extend the wire antenna to
and to set the hour.
and to set minutes.
or down buttons, you can set the next available station.
or down buttons or a longer duration during
PL
EN
FR
NL
21