GET SX1 PRO 2T Manual page 9

8.
Restore the throttle
position adjuster to its
home position:
clockwise 7 full rotations.
Make sure the engine idle speed is stable. If further idle speed
adjustments are necessary, turn the adjustment screw as
indicated in the workshop manual.
If the engine does not start or does not work correctly after
this procedure, for example due to incorrect installation of the
control unit or incorrect idle speed calibration:
1. Uninstall the GET SX1 Pro 2T control unit.
2. Reinstall the original control unit and restore the correct engine
idle speed.
3. Start the motorcycle and check that the engine is working properly.
4. Turn off the motorbike, uninstall the original control unit and
reinstall the GET SX1 Pro 2T control unit.
5. Repeat the Zero TPS calibration procedure.
E. EXHAUST VALVE CALIBRATION PROCEDURE
With the introduction of electronic injection, the exhaust valve is
also controlled by the control unit, which autonomously calculates
its optimal position based on the degree of opening of the throttle
and the engine speed.
When installing a new control unit or other accessories, GET
recommends performing a new calibration of the exhaust valve
end positions.
REMEMBER TO WORK IN SAFE CONDITIONS AND TO
KEEP THE ENGINE TURNED OFF.
rotate
9
7
ROUND
EN