GET SX1 PRO 2T Manual page 5

C. SX1 PRO 2T INSTALLATION
REMEMBER TO WORK IN SAFE CONDITIONS AND TO
KEEP THE ENGINE TURNED OFF.
1.
Identify the original control
unit located under the seat.
Unhook the control unit from the
two side fixing tabs in the under-
seat compartment. Lower the
safety pin, and rotate the OEM
ECU connector before detaching
it: make sure to remove the
connector without damaging it.
2.
Connect the GET SX1 PRO
2T control unit to the original
connector. Make sure that the
connector is inserted correctly
and that the latch is fully engaged.
3.
Insert the GET SX1 PRO 2T
control unit into the GET rubber
support (supplied in the kit).
Fasten the control unit to the two
lateral fixing tabs present in the
compartment under the saddle: to
fasten the device correctly, the ends
of the tabs must protrude slightly
from the GET rubber support.
5
EN