GET SX1 PRO 2T Manual page 6

D. ZERO TPS CALIBRATION
Zero TPS calibration allows the ECU to correctly recognize when
the throttle is fully closed and ensure accurate readings of the
level of fuel injected into the combustion chamber. When installing
a new ECU or other accessories GET recommends performing Zero
TPS calibration.
Idling problems can be caused by incorrect TPS calibration: follow
the steps below to get the best performance from your GET SX1
Pro 2T ECU.
ATTENTION: BEFORE STARTING THE CALIBRATION
PROCEDURE, MAKE SURE THE ENGINE STOP SWITCH
(KILLSWITCH) ALLOWS THE ENGINE TO OPERATE AND
THAT THE THROTTLE IS COMPLETELY CLOSED.
REMEMBER TO WORK IN SAFE CONDITIONS AND TO
KEEP THE ENGINE TURNED OFF.
ZERO TPS CALIBRATION PROCEDURE
1.
Identify the throttle
body on the left side of
the motorcycle, between
the airbox and the intake
manifold.
check your bike's service
manual to find out where
it is located.
Rotate the red throttle
position
counterclockwise 7 full
rotations.
EN
Otherwise,
adjuster
ROUND
6
7