Connecting The Motor - Siemens SIMATIC PDC1000 Equipment Manual

Micro-drive servo drive system drive controller

Hide thumbs Also See for SIMATIC PDC1000:

Table of Contents

Connecting

3.4 Connecting the motor

4. Push the wired connection plug into the socket of the PDC.

5. After connecting, check that the stranded wire or solid conductor cannot be pulled out again.

Connecting of conductors: stranded, without end sleeve, unprocessed

To connect a wire without end sleeve, follow these steps:

1. Strip 8 to 11 mm of insulation from the wires.

2. Press the spring release with the screwdriver, and insert the wire into the spring-loaded

terminal as far as it will go.

3. Let go of the spring release with the screwdriver.

4. Push the wired connection plug into the socket of the PDC.

5. After connecting, check that the stranded wire cannot be pulled out again.

Disconnecting a cable

Press the spring release as far as it will go with the screwdriver. Remove the wire.

Reference

Note the detailed information on the topic "Connecting" in the System Manual SIMATIC MICRO-

DRIVE Drive controller PDC (https://support.industry.siemens.com/cs/ww/en/view/109774126).

3.4

Connecting the motor

Reference

The SIMATIC MICRO-DRIVE drive system is compatible with motors (Dunkermotoren, ebm-papst)

and connecting cables (Harting, KnorrTec) of proven product partners of Siemens. This allows

you to optimally combine suitable products from proven product partners for your individual

application. You can find more information about the Siemens Product Partner Program on the

Internet

industry.html).

(https://new.siemens.com/global/en/company/topic-areas/partners/product-partners-

PDC1000 Drive Controller

Equipment Manual, 12/2023, A5E48775040-AD

Table of Contents