Table of Contents
Advertisement
ProSAFE 8-Port and 16-Port Gigabit Web Managed Click Switch
4.
Click the APPLY button.
You are asked to enter the password for the switch.
5.
Enter the switch's password in the password field.
The switch's default password is password.
The Switch Status page displays.
6.
Select Monitoring > Cable Tester.
7.
Select one or more check boxes.
8.
Click the TEST SELECTED PORT button.
The switch tests the cable connection for the selected ports and displays the results.
Resolve a Subnet Conflict to Access the Switch
If you power on the switch before you connect it to a network that includes a DHCP server,
the switch uses its own default IP address of 192.168.0.239. This subnet might be different
from the subnet used in your network. You might see the following message if you try to use
the ProSAFE Plus Utility to access the switch:
The switch and manager IP address are not in the same subnet.
To fix this subnet conflict:
1.
Disconnect the Ethernet cable between the switch and your network.
2.
Unplug the switch's power cord.
3.
Reconnect the Ethernet cable between the switch and your network.
4.
Plug the switch's power cord into an electrical outlet.
The switch powers on. The network DCHP server discovers the switch and assigns it an
IP address that is in the correct subnet for the network.
Diagnostics and Troubleshooting
79
Advertisement
Table of Contents
