Troubleshooting - Flaem Koala P0615EM User Manual

WARNINGS ON INTERFERENCE RISKS DURING USE IN DIAGNOSTIC IN-
ay
VESTIGATIONS
This device is designed to meet the current requirements for electromagnetic compatibility. As far as
EMC requirements are concerned, electromedical devices require special care when being installed and
used, and are therefore required to be installed and/or used in accordance with the manufacturer's
specifications. Risk of potential electromagnetic interference with other devices. Mobile or portable RF
radio and telecommunication devices (mobile phones or wireless connections) may interfere with the
operation of electromedical devices. The device may be susceptible to electromagnetic interference in
the presence of other devices used for specific diagnosis or treatment. For more information visit www.
flaemnuova.it.

TROUBLESHOOTING

Before performing any operation, switch off the appliance and disconnect it from the mains.
ith
Problem
Thedevice is not
re
working
r
h
The device does not
-
nebulise or nebulises
poorly
ng
The device is louder
or
than usual
If, after checking the conditions described above, the device still is not working properly, we recom-
mend that you contact your trusted dealer or an authorised FLAEM service centre nearest to you. You
can find a list of all Service Centres at http://www.flaemnuova.it/it/info/assistenza
re
ee
Cause
Power supply connections
were not made
correctly
The medicine was not inserted
into the nebuliser
The nebuliser has not been
assembled correctly.
The nebuliser is obstructed
The accessories are not
properly connected to the
appliance
The pipe is bent or damaged
or twisted
The air filter is dirty
The filter is inserted
Remedy
Make the power connections correctly
Pour the medicine into the nebuliser
Disassemble and reassemble the nebuliser
correctly according to the connection diagram on
the cover.
Hygienic preparation of the nebuliser. Deposits
of medicine due to lack of hygienic preparation
of the nebuliser impair its efficiency and function.
Strictly follow the instructions in the HYGIENIC
PREPARATION chapter.
Check the correct connection between the air
inlet of the appliance and the accessories (see
connection diagram on cover).
Unwind the pipe and check it for crushing or
punctures.
Replace it if necessary.
Replace the filter
Insert the filter properly into the housing
15