Advertisement
Operating instructions
Show mode:
To access show mode, press the "MENU" button on the rear of the unit to show "SHOW" on the
LCD display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select between
"SHOW 1 to SHOW 10".
Auto mode:
To access auto mode, press the "MENU" button on the rear of the unit to show "AUTO" on the LCD
display. The fixture will now cycle through the built in programs. If the "SETUP" button is then pressed
the display will now bring up a list of settings within auto mode. These are as follows:
LED:
Press "ENTER" to go into the LED settings. Within this the user can either choose "e-Auto" or "e-Manul".
"e-Auto" - press the "ENTER" button for a menu to adjust the speed and frequency.
"SPEED" - press the "ENTER" button to adjust the speed between "1-20" (1 being slowest,
20 being fastest).
"FREQ" - press the "ENTER" button to adjust the flash speed from "00-20Hz" (00 being lowest,
20 being highest).
"e-Manul" - press the "ENTER" button for a menu to adjust the LED brightness (gray) and frequency.
"GRAY" - press the "ENTER" button to adjust the brightness between "000-255" (000 being lowest,
20 being highest).
"FREQ" - press the "ENTER" button to adjust the flash speed from "00-20Hz" (00 being lowest,
20 being highest).
BAR:
Press "ENTER" to go into the BAR settings. Within this the user can either choose "m-Auto"
or "m-Manul".
"m-Auto" - press the "ENTER" button to adjust the speed between "16" (1 being slowest,
16 being fastest).
"m-Manul" - press the "ENTER" button to adjust the position of the left and right bar.
"L-BAR" - press the "ENTER" button to adjust the left bar between "0-180°".
"R-BAR" - press the "ENTER" button to adjust the left bar between "0-180°".
Sound mode:
To access sound mode, press the "MENU" button on the rear of the unit to show "SOUND" on the
LCD display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select the
sensitivity between "01-31" (01 being lowest, 31 being highest).
Slave mode:
To access sound mode, press the "MENU" button on the rear of the unit to show "SLAVE" on the
LCD display.
www.prolight.co.uk
Vector Beam White User Manual
7
Advertisement
