Leica CINE 1 Quick Start Manual page 29

ASSEMBLING THE OUTER FRAME
▸ Use the longitudinal connector (
▸ Place all parts of the outer frame around the screen ensuring that the outer frame long side (
▸ Position all parts of the outer frame on the edges of the screen. Adjust the cover so the upper and lower cover sections touch and there are no gaps in the
middle. Align the M3x7 screws (
Note: when assembling the outer frame, ensure that there is no screen protection paper, foam, non­woven fabric, or other materials on the edge of the
screen.
Top
Bottom
) and the M3x7 screws ( ) to connect the outer frame long sides (
S N
N ) with the holes as shown in the figure below, then insert and loosely tighten them.
Logo
Back
and ).
L1 L2
) with the logo is at the bottom right.
L1
Back
Logo