Leica CINE 1 Quick Start Manual page 22

ASSEMBLY
The following preparations must be made before commencing assembly.
▸ Create sufficient space on a level and clean floor area. The assembly area should have a minimum size of 3.5 m x 2.5 m (137.8 inches x 98.43 inches).
▸ Lay the white protective sheet (
• Make sure that there are no foreign bodies on or under the protective sheet during assembly.
Note
• More than one of some of the components (e.g. the halves of the frame long sides, spacers, pressure plates) are provided. This can be seen in the figures. In
such cases, the work steps described must be performed multiple times.
ASSEMBLING THE INNER FRAME
▸ Use the longitudinal connectors (
order:
• Use the M4x6 screws ( ) to connect the longitudinal connectors (
E
• Insert the longitudinal connectors (
• Use the M4x6 screws ( ) to connect the longitudinal connectors (
E
) flat on the ground
F
and ) and the M4x6 screws (
Q R
and ) into the inner frame long side (
Q R
) to connect the inner frame long sides (with 17 springs) (
E
and ) to the inner frame long side (
Q R
).
A2
and ) to the inner frame long side (
Q R
and ). Work in the following
A1 A2
).
A1
).
A2
Profile