Leica CINE 1 Quick Start Manual page 28

Pull the screen tight in the direction indi­
cated by the arrow.
• Note: the screen is optimally positioned if the outer edge precisely covers the M4x6 screws (
▸ Once you have attached the corners of the screen, connect the remaining springs in the order 1 → 2 as shown below.
▸ Once you have completed the steps above, stand up the inner frame with the attached screen and check if the screen protrudes over its edges. If this is the
case, release the individual springs and readjust the screen. The screen is correctly positioned if it does not protrude over the edges of the inner frame and all
sides run parallel to the sides of the inner frame.
Use the spring hook ( ) to attach the
K
springs into the holes on the horizontal
and vertical outer edges of the screen.
Repeat the process until all of the springs
have been attached.
E ) indicated above.