Shelves; Shelf Installation; Compressor Mounts - Thermo Scientific 274F Manual

Caution
Remove the banding around the com-
pressor before operation. Verify the
drain tube is not on top of the of the
compressor foot.

Shelves

Included are three (3) epoxy coated wire shelves per door
opening. Also included are three epoxy coated filler
shelves for the two and three door models. Shelf spacing
is adjustable on half-inch centers with the enclosed shelf
supports to suit requirements. Replacement shelves are
available individually. Contact Customer Service for
replacement part numbers.

Shelf Installation

For each shelf, insert four shelf supports at equal heights
onto the pilasters as shown in Figure 2 on the following
page. Shelf supports (2) with 1/2" long tabs are placed in
the two rear pilasters while the 1/4" shelf supports are
placed on the two front pilasters. Place shelf on top of
the shelf supports as shown on Figure 3.

Compressor Mounts

The compressor is secured with steel banding to prevent
damage during shipping. Before operating the compres-
sor, remove the banding. Removing the banding will
allow free movement of the compressor while the freezer
is running. After cutting the banding, verify the drain tube
is not on top of the compressor foot.
I
NSTALLATION
7