Table of Contents
Advertisement
PANEL FACILITIES
@ FREQUENCY /station number display
» FM MONO indicator
ee
eo
Ow
Lights when the FM MONO switch is pressed to select monaural
FM reception.
@ STEREG indicator
This fights during FM stereo reception
@ TUNED indicator
This lights to indicate that a'station has been optimally tuned in.
© STATION CALL switches
These
are used to recall preset broadcasting
stations and to
preset the station.
© MEMGRY switch
This switch is used te memorize stations. When the switch is
pressed, the FREQUENCY
indicator will flash. To memorize the
frequency of any station, press oné'of the STATION CALL switch
while the frequency indicator is ilashing.
@ FM MONO switch
Normatly, the FM MONO indicator remains off. However, it may
not be possible to tune in a desired FM station because it is teo
far away or because its signals are too weak. In cases like these,
press the switch to set the reception to the monaural mode (FM
MOND indicator lights) and tune in the station. The program of an
FM steréo broadcast will be heard in mono. This switch will not
function for AM reception. The FM MONO
setting is memorized
along with station frequency when presetting a station.
® BAND selector switch (FM/ AM)
This is used to select the band of the desired station. The bands
change alternately each time the switch is pressed.
FM reception
Cam reception a
@ TUNING switch (—, +)
These are used to locate stations. Push the
"—" switch to locate
S
<ARBI179>
1-stendby-status-or-when.the-sleép..timer...
function
js
waren the power cord is connected
to a
power outlet.
When the SLEEP key on the remote control unit is pressed, the
sleep function
activated
for approximately
60 minutes,
then
enters
the
standby
mode,
(The
STANDBY/SLEEP
indicator
flashes faster as the end of the set time nears.)
@ POWER (STANDBY/ON) switch
When this switch is set to the ON position, the STANOSY/SLEEP
indicator goes out and poweris supplied to. the main circuits of
the cassette tape deck receiver, The POWER
unit's switch is
geared to selecting the transformer's secondary so that even in
STANDBY
position, the unit's circuitry will work as long as the
power cord is connected to a power outlet.
Disconnect the power cord from the power outlet when you.do
not pian to use the cassette tape deck receiver for a long period
of time.
The cassette tape deck receiver has a backup function, so it
wil return
to the original status
when
the power
cord is i
i unplugged and soon again plugged into the power outlet.
(3 SPEAKERS switch UA, mm A+B)
This is used to select the speaker through which you wish. to
listen.
SBA:
When the speakers connected to A terminals are in
use.
2
A+B:
When the speakers connected to A and B terminals are
in use.
{There is no sound at this position when speakers are
connected only to the A terminais.}
Be sure to use A terminals when you use a pair of speakers only.
- No sound will be heard through the speakers when only a pair of
speakers are connected to 8 terminais.
Advertisement
Table of Contents
