Table of Contents
Advertisement
Tha
lightning
flash
with
arrowhead,
within
en
'equilateral triangle, is intended to atert the user of the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
CAUTION
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT
REMOVE
COVER
{OR BACK}.
NO
USER-
SERVICEABLE
PARTS
INSIDE.
REFER
SERVIC-
ING TO QUALIFIED SERVICE PERSCNNEL,
The exclamation. point within an equilateral triangle is
intended to alert the user of the sresence of important
operating and maintenance {servicing} instructions in
the literature accompanying the appliance.
READ INSTRUCTIONS — All the safety and operating
instructions should be read before the appliance
is operated.
RETAIN INSTRUCTIONS ~ The operating instructions
should be cetained for future reference.
HEEO WARNING — All warnings on the appliance and
in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS — Ail operating and use in-
structions should be followed.
WATER AND MOISTURE ~ The appliance should not
be used near water ~ for example, néar d bathtub,
washbowt, Kitchen sink, Jaundry tub, in a wet
basement, or near a swimming post, etc.
LOCATION ~ The avpitance should be installed in a
stable location.
WALL OR CEILING MOUNTING — The appliance
should not be mounted to a wall or ceiling.
VENTILATION — The appliance should ve situated so.
that its location or pasition does not interfere with
its proper ventilation. For example, the appliance
should not be situated on a bed, sofa, rug, or simi-
tar surface that may block the ventilation open-
ings; or, placed in a built-in instatlation, such as
a bookcase or cabinet that may impede the flow
of air through the ventilation openings.
|. HEAT. -- The. appliance should.be,situated
away-from.
heat sources such as radiators, hea! registers;
stoves, or other dppliances lincluging amplifiers}
that produce heat,
POWER SOURCES ~ The appliance should be con-
nected t@ a power supply only of the type
described in the operating instructions or as
marked on thé doptianes
POWER-CORD PROTECTION ~ Power'supply cords
should be routed so that they aré nat likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cords
at plugs, coriveniénce receptacles, and the point
where
they exit from the appliance.
POLARIZATION — if your Surchased product is provid-
@¢ with 3 polarized power plug. please tead the fol-
Jowing insttuctions. This product is equipped with
'8 polarized aiternating vurrent line plug ta plug hav-
ing one blade wider than the other). This plug will
fit into the power qutlet only
one way. This is a
safety feature. if you are unable
16 insert the plug
fully into the outlet, try reversing the plug. If the
Slug should stil fail to fit, contact your electrician
to replace your obsolete outlet. Donot defeat the
safety purpose of the polarized plug
CLEANING — The appliance should be cleaned only
with a polishing dloth'or a soft dry cloth. Never
clean with furniture wax, berizine, insecticides or
other volatile liquids since they may corrode the
cabinet
POWER LINES — An outdoor antenna should be
located away from power lines
NONUSE PERIODS — The power cord of the appliance
shouid be unplugged from the outlet when left
unused for 2 fong geriod of time.
OBJECT AND LIQUID ENTRY — Caré should be taken
80 that objects do not fal! and liquids are not spilled
into the enclosure through openings.
DAMAGE REQUIRING SERVICE ~ The appliance
should be serviced by a Pioneer authorized service
center or qualified service personnel when:
The power-suppiy cord cr the plug has been
damaged; or
'Objects have falien, or liquid has been spilled into
the apptiance: or
The appliance has been exposed to rain; or
'The appliance does not appear to operate normally
or exhibits a marked change in performance; or
'The appliance has been dropped; or the enclosure
damaged.
SERVICING — The user shouid not attempt to service
the appliance beyond that described in,the oper
ating instructions. For all other servicing. contact
the nearest Pioneer authorized service center.
® 6@
© @
OUTDOOR ANTENNA GROUNDING — If an outside
antenna is connected to the antenna terminal, be
sure the antenna system is grounded so as to pro-
vide some protection against voltage surges and
built up static charges.
in the U.S.A. section 810 of the National Electri-
cal Code, ANSUNFPA No. 70-1984, provides
information with respect to proper grounding of
the mast and supporting structure, grounding of
the fead-in
wire to an antenna discharge unit, size
of grounding conductors, location of antenna dis-
charge unit, connection to grounding electrodes,
and requirements for the grounding electrode. See
Fig. A.
CART — An appliance and cart combination should be
Moved with care. Quick stops, excessive force,
and uneven surfaces may cause the appliance and
cart combination to overturn.
Pie
nee
mS
GROUND
POWER LINES
SERVICE
ENTRANCE
CONDUCTORS +
STAND.OFF
a) Use No. 10 AWG 15.3 mm*) cop-
per, No.8 AWG (8.4 mm?} alumi-
num, No.17 AWG 11.0 mm*)
copper-clad steel, bronze wire, or
larger as ground wire.
b). Secure' antenna iead-in and
ground wires tochouse with stand-
off insulators spaced from 4 feet
TO EXTERNAL
ANTENNA
TERMINALS OF
da)
in enters house.
Use jumper wire noi smaller than
No.6 AWG 113.3 mm*) copper, or
the equivalent, when a separate
antenna-grounding
giectrode, is
WIRE os
ANTERN,
WIRE 2
eva
:
a
onre
See NEC
S e c t i o n £10:21 4
SERVICE ENTRANCE
UNIT ¢
ee
N E C
Section
1 0 : 2 1
4j
EQUIPMENT
'saicae
Wake 3b
GUND
POWER SEAMICE
>
CLAMPS
GROUNDING ELECTRODE SYSTEM
a
4é.g. mteror metal water pipel
.
OPTIONAL ANTENNA
GROUNDING
ELECTRODE
We ORIVEN 8 FEET (2.cam
IC
ito the pari
IE REQUIRED BY
FG
=
LOCAL CODES SEE
NEC SECTION 810-21
{f)
2
<ARB1179>
Advertisement
Table of Contents
