Yamaha YSP-4100 Owner's Manual page 45

Status message
ACQUIRING
UPDATE
FW UPDATING
SUB UPDATED
■ Remote control
Problem
The remote control does not work
and/or function properly.
Cannot operate external
components with the remote
control of this unit.
■ iPod
Problem
No sound.
Controlling volume on the iPod or
iPhone does not work.
Cause
The signal is too weak.
The SiriusConnect tuner is updating the channel list.
The period of the subscription is end.
The SiriusConnect tuner is updating the firmware.
The subscription information is updated.
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an inverter type of
fluorescent lamp, etc.) is striking the remote control
sensor of this unit.
The batteries are weak.
The external component you want to operate is not
selected as the input source.
The remote control code was not correctly set.
Even if the remote control code is correctly set, there
are some models that do not respond to the remote
control.
Cause
PDX-50TX is connected to another device.
PDX-50TX and this unit are not connected since they
are set to different groups.
"Wireless Function" is set to "No".
Distance is too far.
There is a device (microwave oven, wireless LAN,
etc.) outputting signals in 2.4 GHz frequency band
nearby.
The iPod or iPhone is not connected to PDX-50TX
firmly.
The firmware of the iPod or iPhone is not updated.
The signal from PDX-50TX is blocked by your body
or metallic objects, etc.
The battery of iPod or iPhone is low.
The iPod or iPhone is in the process of connecting
with this unit.
The protection circuitry has been activated by
excessive volume.
The iPod or iPhone being used is not supported by
this unit.
The iPod or iPhone is not connected to PDX-50TX
firmly.
Remedy
Adjust the orientation of the antenna of the
SiriusConnect tuner. Use the "Antenna Level"
information on the front panel display to check the
antenna reception level.
Wait until the updating is complete.
Contact SIRIUS Satellite Radio to renew the
subscription.
Wait until the updating is complete.
—
Remedy
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Press the desired DInput selector key to select the
external component you want to operate.
Set the remote control code correctly or try another
code for the same manufacturer using the "List of
remote control codes".
Use the remote control supplied with the external
component.
Remedy
Select the same group ID as selected on this unit.
Set both PDX-50TX and this unit to the same group.
Set "Wireless Function" to "Yes".
Move PDX-50TX closer to this unit.
Move this unit away from the device. If the device is
IEEE802.11n-compliant, change the channel setting
of the device so as not to affect the unit.
Connect the iPod or iPhone firmly.
Download the latest iTunes software to update the
firmware of the iPod or iPhone.
Change the way of holding, orientation, or position of
PDX-50TX to avoid the object blocking the signal.
Charge the iPod or iPhone.
Please wait for a while.
Turn down the volume.
Use an iPod or iPhone supported by this unit.
Connect the iPod or iPhone firmly.
See
page
—
—
27
—
—
See
page
14
—
14
42
42
—
See
page
—
39
39
—
—
—
—
—
—
—
21
30
—
45
En