Displaying The Sirius Satellite Radio™ Information; Playing Back Ipod™/Iphone - Yamaha YSP-4100 Owner's Manual

Use this feature to display the SIRIUS Satellite Radio
TV AV
information on the front panel display.
TV TV AUX 1 AUX 1 AUX 2 AUX 2
D
HDMI 1 HDMI 1 HDMI 2 HDMI 2 HDMI 3 HDMI 3
HDMI 4 HDMI 4 iPod iPod RADIO RADIO
ENTER
MOVIE MUSIC TAINMENT OFF
• If a status message or an error message appears on the front
CINEMA DSP
SURROUND STEREO
Press RINFO repeatedly to toggle the following
ENTER
SIRIUS Satellite Radio information display
TOP MENU MENU
modes.
OPTION SETUP RETURN
TV VOL CH VOLUME
K
TV TV
MUTE INPUT MUTE MUTE
M
UNIVOLUME SUR. DECODE INTELLIBEAM
1 2 3
4 5 6
7 8 9
0 +10
ENT
CODE SET
TUNING PRESET CATEGORY
Q
INFO INFO MEMORY SLEEP SLEEP
R
By using the Yamaha wireless transmitter for iPod (PDX-
50TX/PDX-50BC), you can use the iPod/iPhone as a
remote control and enjoy playback of your iPod/iPhone on
this unit. About PDX-50TX/PDX-50BC, refer to "Safety
and Accessory Information" (separate booklet).
See also: "iPod Interlock" (page 39)
y
• This unit supports the following iPod/iPhone models.
• Be sure to use the product only in the country in where it was
• This unit does not support iPod (4th generation or before), iPod
• You cannot run the AUTO SETUP while playing back the iPod/
DiPod
KVOLUME +/–
MUNIVOLUME
QSLEEP
RINFO
30
En
Displaying the SIRIUS Satellite
Radio™ information
Note
panel display, see "SIRIUS Satellite Radio" (page 44).
Channel
Category
Artist / Song
Composer
Antenna Level
(Antenna reception level)
– iPod 5th generation
– iPod classic
– iPod touch
– iPod nano
– iPhone
– iPhone 3G
Notes
purchased.
without Dock connector, iPod photo and iPod mini.
iPhone by using PDX-50TX. To run the AUTO SETUP, stop
playback and then disconnect the iPod/iPhone from PDX-
50TX.
Display example (Artist / Song)
y
• If the SIRIUS Satellite Radio information contains a character
• When the antenna of the SiriusConnect tuner cannot receive the
• When an information is unavailable, "––––" appears.
Playing back iPod™/iPhone™
Connect your iPod/iPhone and PDX-50TX, and
then start playback.
SIRIUS
that cannot be recognized by this unit, the character will be
displayed with a space.
signals, "ACQUIRING" appears on the front panel display.
MENU
y
• When you start playback of your iPod/iPhone, this unit
automatically operates as follows.
– When this unit is on, this unit selects "iPod" as the input
source.
– When this unit is in the standby mode, this unit turns on
and selects "iPod" as the input source.
• You can also select the input source with DiPod.
• To adjust the volume level, use the volume control on the
iPod/iPhone or KVOLUME +/– on this unit.
• This unit automatically turns to the standby mode in the
following conditions.
– The iPod/iPhone is disconnected from PDX-50TX.
– The iPod/iPhone is turned into sleep mode.
INPUT VOLUME INTELLIBEAM MIC