MxNVR-IA8
ATTENTION
The power supply used for this product is the Listed Power Unit, with LPS-marked, 12 to 32 VDC power output.
ATTENTION
Before connecting the VPort to the DC power inputs, make sure the DC power source voltage is stable.
Wiring the DI/DO
The MxNVR-IA8 comes with a 6-ch digital input and a 2-ch digital output through a terminal block connector.
DI Dry Contact Wiring
10/100/1000BaseT(X) Ethernet Port Connection
The 10/100/1000BaseT(X) port located on the MxNVR-IA8 rear panel is used to connect to Ethernet-enabled
devices.
The following table shows the pinouts for both MDI (NIC-type) ports and MDI-X (HUB/Switch-type) ports. We
also show cable wiring diagrams for straight-through and cross-over Ethernet cables.
10/100BaseT(X) RJ45 Pinouts
(MDI) Port Pinouts
Pin
1
2
3
6
DI Wet Contact Wiring
(MDI-X) Port Pinouts
Signal
Tx+
Tx-
Rx+
Rx-
Pin
Signal
1
Rx+
2
Rx-
3
Tx+
6
Tx-
2-11
Getting Started
DO Wiring
8-pin RJ45