Getting Started - Ribimex PRMPP080/17 Instructions Manual

1. Remove the filler cap/dipstick and wipe it
clean.
2. Insert and remove the dipstick without
screwing it into the filler neck. Check the oil
level shown on the dipstick.
3. If the oil level is low, fill to the edge of the oil
filler hole with the recommended oil.
4. Screw in the filler cap/dipstick securely.
3.5.2- Engine oil recommendations
Oil is a major factor affecting performance and service life.
Use 4-stroke automotive lubricating oil.
SAE 15W-30 is recommended for general use.
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
- Make sure you have all the below components:
4.2- Assemble
The pump is delivered pre-assembled.
4.3- Hose assembly
Important: use only a PVC suction ringed hose or other hose with similar quality (not included).
- 20 -