Getting Started; Operation - Ribimex PRBAT20 User And Maintenance Manual

IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging.
• Check if the product and accessories (if any) are intact.
4.2- Assembly
• No assembly or adjustment is required by the user.
4.3- Charging the battery
• Follow the instructions of the battery and charger to properly charge the battery.
4.4- Switch On/Off
• Install the fully charged battery pack into battery compartment (1).
• Set the power switch (6) to "ON" position, then the pump starts to run.
• To switch off the pump, set the power switch (6) to "OFF" position.
V. OPERATION
5.1- Intended use
This product is intended for domestic use in transferring clean non-drinking water or diesel from
reserviors, tanks and drums.
Below liquids are unauthorized with this product:
Unauthorized liquids
Petroleum, solvents, flammables or explosive liquids
Detergents, bleach
Liquid food
Liquids with high viscosity > 10 cSt
Corrosive liquids

5.2- Operation

Before use
• Inspect the general condition of the pump, hose and connections. Make sure they are not
worn or damaged or leaked.
• Make sure battery pack is sufficiently charged and properly installed.
After use
• Switch off the pump.
• Remove the battery pack from the tool.
• Clean the product exterior surface.
Potential hazards
Fire / Explosion
Pump damage
Contamination
Motor overload
Pump damage / Personal injury
Page 11 / 19