Ribimex PRMPP080/17 Instructions Manual page 24

Assemble the intake hose joint and the intake (suction) hose (not supplied) and drain hose to the
water pump. Proceed as follows;
1. Insert the couplings into the suction and discharge hoses
2. Use the clamps and tape (not supplied) and tighten firmly.
Then screw the hose couplings to the pump suction inlet and discharge port.
3. Insert strainer in suction hoe.
4. Use the clamps and tape (not supplied) and tighten firmly
Note: Make sure the washer is properly fitted on the intake hose coupling.
If the washer of the suction hose is loosened, or the hose buckle is lost or damaged, the water will not
be pumped properly due to air leakage.
4.4- Before starting engine
Note: Check that both suction hose and discharge hose are properly assembled.
Note: Press the fuel priming bulb at the bottom of the carburetor several times with your fingers
before starting until the fuel flows into the transparent plastic bulb.
Note: Before each use, ensure that both fuel tank and oil tank are fully filled in. Refill if necessary
1. Fill water into the self-priming port to make the intake hose and the water pump full of water.
Proceed as follows:
IMPORTANT: A continual idling or operation without water in the pump will lead to its
damage. So before starting the engine, please make sure that the pump has been refilled water.
If the suction hose strainer appears above the water in the course of operation, stop the engine
as soon as possible.
2. Make sure that the joint of the suction hose is tightened. Otherwise the air leakage will lead to no
- 21 -