Transport; Storage; Care And Maintenance; Troubleshooting - Kärcher Puzzi 10/1 Manual

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Illustration
 For transport, place suction pipe on the
carrying handle and place the spray/
suction hose on top of the appliance.
Wind up the mains cable and hook it
into the cable hook.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
Danger of injury by electric shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Clean the fluff filter
 Remove the lid.
 Remove the wastewater container from
the appliance.
 Regularly clean the lint trap using a
brush.
Cleaning the fresh water sieve
 Unscrew the fresh water sieve.
 Regularly clean the fresh water sieve
under running water.
Cleaning the nozzle
 Unscrew the covering nut.
 Clean nozzle mouthpiece.

Troubleshooting

DANGER
– Danger of injury by electric shock.
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
– Get the electrical components checked
and repaired only by authorised cus-
tomer service persons.
Appliance is not working
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
 Turn on the appliance.
No water exiting from nozzle
 Fill up fresh water reservoir.
 Check the couplings on the spray hose
for proper seating.
 Clean or replace nozzle tip.
 Clean the sieve in the fresh water reser-
voir.
 Spray pump defective, contact after-
sales service.
Spray stream one-sided
 Clean nozzle mouthpiece.
Insufficient vacuum performance
 Check the correct positioning of the lid.
 Clean seal on lid and surface on the ap-
pliance.
 Clean the fluff filter.
 Check suction hose for blockages;
clean if required.
Spray pump loud
 Fill up fresh water reservoir.
Heavy formation of foam in the
wastewater container
 Add the defoaming agent into the
wastewater container or fill up the con-
tainer for the defoaming agent.
– 5
EN 15