Yamaha DSP-A5 Owner's Manual page 48

TROUBLESHOOTING
Remote control
SYMPTOM
The remote control does
not work.
The unit or other
component cannot be
controlled.
Others
SYMPTOM
The sound is degraded
when listening with
headphones to a tape
deck or CD player
connected to this unit.
There is noise
interference from digital
or high-frequency
equipment, or the unit.
46
CAUSE
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The batteries are weak.
The component to be controlled has not been
selected.
The remote control cannot control system
components.
The manufacturer's code has not been set
properly.
Depending on the manufacturer or the model,
some components cannot be controlled with this
unit's remote control even though the code has
been set properly.
CAUSE
This unit is in the standby mode.
The unit is too close to the digital or high-
frequency equipment.
REMEDY
Reposition the unit.
Replace all batteries with new ones.
Set the selector dial to the appropriate position,
corresponding to the component to be
controlled.
Enter the code again.
Try setting another code for the same
manufacturer.
Use the original remote control supplied with
your component.
REMEDY
Turn on the power of the unit.
Move the unit further away from such
equipment.
Refer to
page
3
2
36
—
42
—
Refer to
page
—
—