Advertisement
Listing the
Calculator
Status
Stopping
theListing
Press
<ST>tolist the currentcalculatorstatus.
Thecalculatorlists the currentpartition settings and
each parameterthatis not currentlysetto its default
setting. (Parameters thatare currently set to their
default settings are notlisted.)
Thelist is displayed at a one-secondrate. You can use the
[=] keyto control the speedofthe listing.
If you have a PC-324printer attached, thelisting is also
printed. For more information, refer to Chapter6,
"Using an Optional Printer."
Thelist below showsall possible statuses.
Partition (memory)
Angle mode(degrees, radians, or grads)
Hexadecimal mode(with or without two's complement)
Octal mode(with or without two's complement)
Flags set (flag numbers)
Fixed decimal(places)
Module(installed)
Wordbreak mode(if turned on)
Print device (number)
Print width (number)
System mode(if selected)
Lasterror(since[LIST] <ST> functionlast used)
To stopa listing beforeall register contents or status
messages have beendisplayed, hold down the
or
keyuntil the wordLIST:is displayed.
After youstop a listing, you can perform other
operations oryoucan list the registers again by selecting
<REG). Thelist beginsat the numberin the display,
register. If an alpha messageis in the display, you can
press [CE] to see the number.
Memory Operations
5-13
Advertisement
