Advertisement
8.
Remove the blender from the Motor Unit (turning the blender counterclockwise),
carefully remove lid, and then pour and serve.
Food Processor
1.
Begin by assembling the drive shaft into the motor base, ensuring it is securely
clipped into position.
2.
Place the bowl on the motor base from the unlock position and gently turn the
bowl clockwise until it locks into the position on the motor base. Confirm that it is
correctly assembled, as the appliance will not operate otherwise.
3.
Insert the knife blade securely into the drive shaft in the bowl, ensuring it is locked
into position.
4.
Place the prepared food into the bowl. The food must be cut into small pieces first
(e.g., 2cmx2cmx6cm for beef). While chopping, use the feeding funnel and pusher
to add food.
Warning: Never use of hands or fingers to push food into the feeding funnel.
5.
Place the lid onto the bowl and turn it clockwise until the tab of the lid clicks into
the slot in the bowl handle. Confirm that it is securely locked in position; otherwise,
the appliance will not operate.
6.
Connect the appliance to the power supply and set the Speed Selector to your
desired speed. There are four settings: P, 0, 1, 2:
o
o
o
o
Caution: The total operating time should not be more than 90 sec. You can chop
up to 400g of following ingredients:
o
o
o
7.
Turn the Speed Selector to "0" position and unplug the appliance after chopping.
Open the top lid and grasp blade by its hub and remove. Unlock chopping jar by
turning it in anti-clockwise away from motor base and lift it off. Empty the
processed food.
Caution: The "S" blade is extremely sharp, handle with care.
Tip:
For a quick wash between processing, pour some water into the bowl, turn and hold the
speed selector to "P" position a few seconds.
0 - off
1 - low speed
2 - high speed
P - pulse
Hard ingredients: cheese, dried fruits and certain vegetables (carrots,
celery etc.)
Soft ingredients: certain vegetables (onions, spinach etc.)
Raw and cooked meat (boned and sliced)
Advertisement
