Sony RSE-500 Operating Instructions Manual page 44

You can check alarm signals and log files in list view.
You can also set the bit value of the RELAY OUT
port.
Checking the Alarm Signals and
Log File of the ALARM IN Port
The following describes how to check the ALARM IN
port status.
To move from page to page on the ALARM IN
list
To check the alarm signal list
Move the cursor to <♦> using or then press
To check the local site's alarm signal to the
ALARM IN port, select LOCAL ALARM from
the main menu.
To check the remote site's alarm signal to the
ALARM IN port, select REMOTE ALARM from
the main menu.
The following screen appears. (The illustration
below is for selecting LOCAL ALARM.)
ENTER. Each time you press ENTER, the next alarm
signal list is displayed.
Move the cursor to <♦> using ♦ or ♦, then press
ENTER. Each time you press ENTER, the previous
alarm signal list is displayed.
To return to the main menu
Move the cursor to <EXIT> and press ENTER. The
main menu appears.
Move the cursor to <START> using then press
ENTER.
The system starts to check the ALARM IN port.
If an alarm has generated, the alarm signal list is
displayed.
To check the ALARM IN port log file list
You can check the log file list on the ALARM IN port.
Up to 128 log data items are stored in the list. If the list
is full, the oldest log is deleted when a new one is
entered.
1
To check the local site's log file list on the
ALARM IN port, select LOCAL ALARM from
the main menu.
To check the remote site's log file li,st on the
AL.\RM IN port, select REMOTE ALARM from
the main menu.
The following screen appears. (The illustration
below is for selecting LOCAL ALARM.)
2
Move the cursor to READ LOG FILE using ♦,
then press ENTER.