Table of Contents
Advertisement
Chapter 10 Appendix
Chapter 10 Appendix
TeraStation Does Not Work Properly
If an error occurs that prevents the TeraStation from booting up properly, one or more of the following symptoms
may occur. In such a case, try the corresponding corrective action to recover from the error, described in each
section below. If the error is still not resolved, contact Buffalo technical support for assistance.
• The power LED keeps blinking instead of turning into a solid glow; follow the procedure at the
Blinking"
section below.
• An "i" symbol is displayed with the TeraStation icon and the
step 3 and after at the
• An "i" symbol is displayed with the TeraStation icon and "EM" is added to your TeraStation's hostname on NAS
Navigator2; follow the procedure at the
Power LED Keeps Blinking
While the TeraStation's power LED keeps blinking, you may see the
follow the procedure below to recover from drive setup mode.
1
Press and hold down the power button for three seconds to turn off the TeraStation.
2
Turn it on while holding down the function button. You should hold down the function button for at least 10
seconds after pressing the power button.
3
When the power LED changes from blinking to glowing, let go of the function button and open Settings from
NAS Navigator2.
4
Make sure that "Recover firmware" is selected from the drop-down list under "Action", then click Start Setup.
Note: There are two more options for "Action" other than "Recover firmware". The details for all options are
below:
"Power LED Keeps Blinking"
"Booting the TeraStation in Emergency Mode"
I61
message appears on NAS Navigator2; follow
section below.
I61
message on NAS Navigator2. In such a case,
219
"Power LED Keeps
section below.
Advertisement
Table of Contents
