Table of Contents
Advertisement
Chapter 7 Advanced Features
7
The TeraStation will save the settings. When saving settings is completed, click OK.
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive an error message such as "The specified
operation cannot be executed. " . Verify:
• The USB drive has a capacity of 1 GB or more.
• The USB drive is not write-protected.
• Failover is configured on the TeraStation.
Applying Settings
The saved settings can be applied to a different TeraStation of the same series. If applying settings to another
TeraStation, the unit's current firmware version will be changed to the version used to save the settings.
Notes:
• The saved settings on the TS3010 series TeraStations cannot be applied to the TS3020 series TeraStations and vice
versa.
• Since firmware version 4.36, saved settings cannot be applied from a USB drive that contains saved settings from
a unit that was running a firmware version earlier than 4.36. In such a case, create the settings restoration USB
drive again using a unit running firmware version 4.36 or later.
1
Insert the USB drive with the saved settings into a USB port on the TeraStation.
2
From Settings, click Management.
3
Click the settings icon (
4
Select "Transfer settings from a USB drive".
5
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation, then click
Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will apply the settings. When applying settings is completed, click OK.
) to the right of "Configuration Management".
181
Advertisement
Table of Contents
