Memory Only Mode - Yaesu FT-7800R Operating Manual

R
EGULAR
Memory Bank Recall
1. Set the radio to the Memory mode by pressing the [ V/M ( MW )] key, if necessary.
2. Press and hold in the [ SCAN ( SEL )] key for 1/2 sec-
ond, then rotate the DIAL knob to select the Memory
Bank ("BANK 1" ~ "BANK20").
3. Press the [ BAND ( SET )] key momentarily to lock in the selected Memory Bank.
4. In the Memory Bank mode of operation, you can only select memory channels within the
current Memory Bank.
5. To change the Memory Bank to another Bank, press and hold in the [ SCAN ( SEL )] key
for 1/2 second; now rotate the DIAL knob to select the new Memory Bank, then press the
[ BAND ( SET )] key momentarily to lock in the new Memory Bank.
6. To exit from Memory Bank operation, press and hold in
the [ SCAN ( SEL )] key for 1/2 second, then rotate the
DIAL knob to select "NOBANK;" now press the
[ BAND ( SET )] key momentarily.
Deleting a Memory Channel from a Memory Bank
1. In the Memory Bank mode, recall the memory channel to be deleted from the Memory
Bank.
2. Press and hold in the [ SCAN ( SEL )] key for 1/2 second, then press and hold in the
[ V/M ( MW )] key for 1/2 second. The channel will now be deleted from the Memory
Bank, but the memory register itself will still be available in the non-Bank mode.

Memory Only Mode

Once memory channel programming has been completed, you may place the radio in a
"Memory Only" mode, whereby VFO operation is impossible. This may be particularly
useful during public-service events where a number of operators may be using the radio for
first time, and ultimate simplicity of channel selection is desired.
To place the radio into the Memory Only mode:
1. Turn the radio off.
2. Press and hold in the [ MHz ( PRI )] key while turning the radio on.
3. Rotate the DIAL knob to select the (F-6 M-ONLY) op-
tion, then press and hold in the [ BAND ( SET )] key for
1/2 second.
To return to normal operation, repeat the above steps.
FT-7800R O
M
M C
EMORY
M
O
EMORY
O
HANNEL PERATION
PERATION
37