Table of Contents
Advertisement
8) Push the button
"Erase-Program-
Verify.
9) Software will start
to erase the old
firmware and up-
load the new one,
then will check the
FW integrity.
10) Once done push
Run Application.
11) The software will
disconnect the
unit that will turn
to operative mode
with the new FW
installed.
IMPORTANT:
Don't push the But-
tons "Connect DRV1 DRV2 DRV3
and DRV4". These are needed
when De Sisti releases also new
DRV FWs for massive changes. The
procedure to upload the FW is the
same than the CPU one but, as it's
possible to DAMAGE the unit
DRIVER it must be done by or with
the support of a qualified DE SISTI
assistant person.
ILT ITALY srl
Via Cancelliera, 10/a
00041 Albano Laziale (Rome) Italy
tel. +39 06-902901 fax +39 06-90231051
www.desisti.it
This Manual is applicable to the De Sisti – Storaro The Muses of Light - POLYMNIA
Revised on March 2021
Advertisement
Table of Contents
