Table of Contents
Advertisement
Cleaning/replacing the electrodes
ATTENTION: avoid the electrodes to get in touch with metallic parts (blast tube, head, etc.), otherwise the boiler operation
would be compromised. Check the electrodes position after any intervention on the combustion head.
To clean/replace the electrodes, proceed as follows:
1
remove the combustion head as described in the previous paragraph;
2
remove the electrodes ass.y and clean them;
in order to replace the electrodes, unscrew the VE fixing screws and remove them: place the new
electrodes being careful to observe the measures in the previous paragraph; reassemble the electro-
des and the combustion head following the reversed procedure.
Cleaning and replacing the detection photocell
To clean/replace the detection photocell, proceed as follows:
1
Disconnect the system from the electrical power supply.
2
Shut off the fuel supply;
3
remove the photocell from its slot (see next figure);
4
clean the bulbe if dirty, taking care not to touch it with bare hands;
5
if necessary, replace the bulb;
6
replace the photocell into its slot.
Checking the detection current
To check the detection signal follow the scheme in the picture below. If the signal is less than the value indicated, check the position of
the detection electrode or detector, the electrical contacts and, if necessary, replace the electrode or the detector.
Flame sen-
Control box
LMO44
LAL2..
Seasonal stop
To stop the burner in the seasonal stop, proceed as follows:
1
turn the burner main switch to 0 (Off position)
2
disconnect the power mains
3
close the fuel valve of the supply line
Burner disposal
In case of disposal, follow the instructions according to the laws in force in your country about the "Disposal of materials".
Minimum detec-
sor
tion signal
QRB4
45μA
QRB1
95μA
MC TERMINAL BLOCK
+ (BK)
- (BU)
35
PART IV: MAINTENANCE
VE
34 35
Advertisement
Table of Contents
