Tektronix Phaser 840 Install Manual page 17

Connect to a Macintosh: Ethernet-direct connection
N
O T E
For setting up the printer with a LocalTalk card, see the PhaserShare
Networking Setup Guide.
Requirements
Two RJ-45 twisted-pair 10Base-T cables
An Ethernet-port hub
1.
Turn off your computer and the printer.
2.
Connect one end of an Ethernet cable to the Ethernet port on your
Macintosh computer. Connect the other end to the hub.
3.
Connect the other cable to the hub and the Ethernet port on the printer.
C
A U T I O N
The printer is not a SCSI device. Do not connect the printer to your
computer through the SCSI ports.
4.
If you are connecting any optional peripheral devices, such as a scanner, do
so now; refer to page 12 for guidelines. Otherwise, turn on your computer
and printer, refer to page 14.
2
5.
At your computer, from the Apple menu, select Control Panels, then
select AppleTalk; the AppleTalk dialog box opens.
6.
At the Connect via pull-down menu, select Ethernet built-in. Close the
dialog box.
7.
Proceed to "Macintosh software" on page 30.
3
Setup Guide
Getting Set Up
0389-43
11