2. Layout and items supplied Danger! When using the equipment, a few safety pre- cautions must be observed to avoid injuries and 2.1 Layout (Fig. 1-4, 13, 16) damage. Please read the complete operating 1. Air cap retaining ring instructions and safety regulations with due care. 2.
• Container Wear ear-muff s. • Cleaning brush (not shown) The impact of noise can cause damage to hea- • Cleaning needle ring. • Viscosity cup • Total vibration values (vector sum of three direc- • 2.5 mm nozzle, mounted on the pistol tions) determined in accordance with EN 50580.
5. Before starting the equipment To ensure that the battery pack provides long ser- vice, you should take care to recharge it promptly. You must recharge the battery pack when you Warning! notice that the performance of the device drops. Always remove the battery pack before making Never allow the battery pack to become fully di- adjustments to the equipment.
Page 18
of the bottom is interrupted, stop the timer. the air cap (2) to the desired position. Re-tighten Repeat until you have the viscosity you need. the air cap retaining ring. This is the „Draining time in seconds“. (See 10. Selecting the fan pattern: Viscosity Table) A: vertical fan ->...
6.6 Disconnecting and cleaning the gun and regulations. Residual paint and solvents (Fig. 1-2, 11-15) must be taken to a suitable collection point. If you are not sure, ask the local council where Danger! the nearest collection point is. Always pull out the battery pack before starting Warning! any cleaning work.
The reprinting or reproduction by any other me- ans, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of the Einhell Germany Subject to technical changes - 20 - Anl_TC_SY_18_60_Li_SPK7_THA.indb 20 Anl_TC_SY_18_60_Li_SPK7_THA.indb 20...
12. Charger indicator Indicator status Explanations and actions Red LED Green LED Off Flashing Ready for use The charger is connected to the mains and is ready for use; there is no battery pack in the charger Off Charging The charger is charging the battery pack in quick charge mode. The char- ging times are shown directly on the charger.
* Not necessarily included in the scope of delivery! Please register the product warranty of Einhell brand products. Customers must scan the QR Code of the Serial number in the product or QR code on the box, to additional 6 months warranty for the whole battery and battery charger (Note: Promotion is change without prior notice.
Need help?
Do you have a question about the TC-SY 18/60 Li and is the answer not in the manual?
Questions and answers