Table of Contents
Advertisement
SUN2000-(3KTL-10KTL)-M1 Series
User Manual
● To prevent dust inhalation or contact with eyes, wear safety goggles and a dust
● Clean up any dust in and around the holes using a vacuum cleaner and
● Level the top of the expansion sleeve with the concrete wall after removing the
● Loosen the nuts, flat washers, and spring washers of the two expansion bolts
Figure 4-9 Installing the mounting bracket
Step 3 (Optional) Install the locking screw for the DC switch.
Figure 4-10 Installing the locking screw for the DC switch
Step 4 Install the SUN2000 onto the mounting bracket.
Step 5 Tighten the nut.
Issue 17 (2024-01-12)
NO TICE
mask when drilling holes.
measure the distance between holes. If the holes are inaccurately positioned,
drill holes again.
bolt, spring washer, and flat washer. Otherwise, the mounting bracket will not
be securely installed on the concrete wall.
below.
NO TE
● The locking screw for the DC switch is delivered with the SUN2000. According to the
Australian standard, the locking screw is used to secure the DC switch to prevent the
SUN2000 from being started by mistake.
● For the model used in Australia, perform this step based on the local standards.
Copyright © Huawei Technologies Co., Ltd.
4 Installation
33
Advertisement
Table of Contents
