Klarstein BRISA Manual page 40

EN
40
• Metal grease fi lters do not need to be replaced when they are over-saturated,
but washed once a month by hand or in the dishwasher (60 °C). Allow the fi lter
to dry thoroughly and carefully reinsert it in the cooker bonnet. Do not use
alkaline dishwashing detergents (pH value above 7).
Activated carbon fi lter
a) Conventional activated carbon fi lters (usually round) cannot be washed or
reused. With normal use and depending on the size, they should be replaced every
4 to 6 months. Follow the relevant instructions on the packaging.
b) Washable and reusable activated charcoal fi lters (usually square) should be
cleaned once a month in the dishwasher using a commercial detergent and the
intensive rinse programme (at the highest temperature). Washable and reusable
activated charcoal fi lters absorb kitchen odours for a maximum of 3 years when
cleaned monthly. After this period, the fi lter should be replaced with a new one.
• Washable and reusable activated charcoal fi lters should be washed separately
to avoid deposits of food residues that can later cause unpleasant odours.
After washing, the washable and reusable activated carbon fi lter must be
reactivated. This is done by drying the cleaned fi lter in the oven at 100 °C for
10 minutes. Read on the packaging whether your activated charcoal fi lter
is washable and reusable. If there is no indication on the packaging, it is a
conventional, non-washable activated charcoal fi lter.
• After each change or washing of a grease fi lter or charcoal fi lter, clean all
exposed lower parts of the extractor bonnet with a mild grease solvent. For
daily cleaning of the outer surfaces of the bonnet, use a soft cloth moistened
with alcohol or a mild liquid cleaner. Never use an abrasive cleaner. There is a
risk of fi re if the instructions for cleaning the extractor bonnet and changing
or cleaning the fi lters are not followed.
WARNING
Risk of fi re! Always follow the instructions for cleaning the cooker
bonnet and fi lters.
Lighting
This appliance has a built-in LED strip. This strip does not need to be replaced.