Performing The Test; Disconnecting The Gas Cylinder; Replacing The Gas Cylinder - TEFAL JM4130 Manual And Safety Instructions

• Make sure that you are a safe distance from any sources of heat (cigarettes, electrical ap-
pliances etc.).

PERFORMING THE TEST

1 - Turn the oven control knob to the off position. The leak test must be carried out using soapy
water. Never use a flame to check for leaks.
2 - Apply the soapy water solution to all of the gas connections.
3 - Open the valve on the gas cylinder and check for bubbles. If bubbles form, this indicates that a
leak is present.
-> If you detect a leak, immediately turn off the gas supply and tighten the connections.
4 - Reopen the valve and perform a second leak test to check the connection again.
-> If the leak persists or comes from another part, turn off the gas supply, do not use your
oven and contact customer services. Never use a leaking appliance.

DISCONNECTING THE GAS CYLINDER

1 - Turn the oven control knob to the off position. Ensure that the valve of the gas cylinder is in the
closed position.
2 - Disconnect the regulator from the valve of the cylinder by turning the coupling nut anticlo-
ckwise.
3 - Always place the dust cap on the outlet valve of the gas cylinder when not in use.

REPLACING THE GAS CYLINDER

• The gas cylinder must always be replaced with the control levers and the valve of the gas
cylinder closed.
• Replacement of the gas cylinder must always take place in a well-ventilated area away from any
sources of heat (cigarettes, electrical appliances, etc.).
• Perform a leak test each time the gas cylinder is replaced.
GAS CYLINDER WARNING
• Do not store the replacement gas cylinder under or close to this appliance
• Never fill the cylinder beyond 80% of its capacity
• The gas cylinder must be equipped with an OVERFILL PREVENTION DEVICE (OPD)
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY INCREASE
THE RISK OF FIRE RESULTING IN DEATH OR SERIOUS INJURIES.
7