Advertisement
V. USAGE INSTRUCTION
MANUAL RESET
It is necessary to be reset manually after the initial installation and power switched off.
1.
Keep pressing
down slowly to the lowest, then release
NOTE: The anti-collision function is not enabled during all resets. Please note that there is a
potential risk of pinching in this case and be sureno obstacles in the desk's path.
UP AND DOWN
1.
Keep pressing "up" key until the required height is reached.
2.
Keep pressing "down" key until the required height is reached.
SAVING POSITION
1.
Adjust the heights of the desktop you want to save by the two buttons.
2.
Press "M" and Numbers and STo will flash alternately ("Save" action will stop within 5
seconds if no further operation), then press number 1/2/3 to save Height 1/2/3.
and
until the display shows "rST" and the desktop starts moving
and
to reset the system.
USAGE INSTRUCTION |
11
Advertisement
