Unix (Linux); Quick Install Steps - Xerox Phaser 4510 Advanced Features Manual
Xerox phaser 4510: supplementary guide
Hide thumbs
Also See for Phaser 4510:
- User manual (145 pages) ,
- Quick use manual (6 pages) ,
- Install manual (4 pages)
Table of Contents
Advertisement
UNIX (Linux)
Your printer supports connection to a variety of UNIX platforms through the parallel and
network interface. The workstations currently supported by CentreWare for UNIX/Linux to a
network-connected printer are:
■
Sun Solaris
■
IBM AIX
■
Hewlett-Packard HP-UX
■
DEC UNIX
■
Linux (i386)
■
Linux (PPC)
■
SGI IRIX
The following procedures enable you to connect your printer using any of the supported
versions of UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the appropriate drivers.
From the Printer
To set up the printer:
1.
Verify that both TCP/IP protocol and the proper connector are enabled.
2.
On the control panel, select one of these IP address options:
■
Allow the printer to set up a DHCP address.
■
Enter the IP address manually.
3.
Print the Configuration page and keep it for reference.
Phaser® 4510 Laser Printer
3-15
UNIX (Linux)
Advertisement
Table of Contents
Troubleshooting
