Xerox Phaser 4400 Support Manual page 14

Do not place the printer near a heat source.
I
Do not place the printer in direct sunlight.
I
Do not place the printer in line with the cold air flow from an air conditioning system.
I
Place the printer on a level, solid surface with adequate strength for the weight of the machine. The
I
base printer weight without any packaging materials is approximately 25 kg (55 pounds).
The printer is heavy, and must be lifted by two people. The illustration below shows the proper
I
technique for lifting the printer.
Note
Do not use the Multi-Purpose Tray or envelope feeder to lift the printer.
Follow the recommended procedure when moving the printer from one location to another. You
I
can find this procedure in the Moving Guide section located in the Setup Guide of the Interactive
Documentation CD-ROM.
Do not place any liquids on the printer.
I
Warning
Be careful when working in areas inside the printer identified with a warning symbol. These
areas may be very hot and could cause personal injury.
Wait 10-15 seconds between switching the printer off and on.
I
Keep hands, hair, neckties, etc., away from the exit and feed rollers.
I
While printing, follow these safety guidelines:
Do not remove the paper source tray that you have selected in the driver or front panel
I
Do not open the covers while printing.
I
Do not move the printer while printing.
I
Phaser™ 4400 Laser Printer
25 kg
55 lbs.
P4400-93
User Safety Summary
11