Electrical Information - Bering 3000 Series User Manual

A-4
MISCELLANEOUS TECHNICAL INFORMATION
A.2 Electrical Information
***
LINE VOLTAGE
***
When the disk subsystem is shipped, it should have already been set to the line
voltage specified in your order. The configured line voltage should be either
110 Vac, or 220 Vac (see Table A.l). Field reconfiguration of voltage setting
;s not allowed. When reconfiguration is required, please consult the factory.
***
FUSES
***
Table A.1 Voltage Setting
line Voltage Range Configured Voltage
90V
to
132V 110V
198V to 264V 220V
When the disk subsystem is shipped, there is always a spare fuse in
the fuse compartment of the power/fuseholder receptacle.
The fuse compartment is located in the lower portion of the
power/fuseholder receptacle. It can be opened by using a small screw
driver or similar object.
Di sk Model
38xx
Others
Line-Voltage
110/220
Vac
1101220
Vac
Fuse type
3.15 A, Slow blow, 5 X 20 mm
1.6 A, Slow blow, 5 X 20 mm
Users are urged to verify the fuse visually before power-up to
avoid possible safety hazard and damage to the disk subsystem. DO NOT
USE A FUSE WITH A HIGHER RATING THAN rHE SPECIFIED TYPE.
*****************************************************
WARNING
DISCONNECT THE DISK SUBSYSTEM UNIT fROM ANY
POWER SOURCE BEFORE CHANGING FUSES
*****************************************************