Model 30Xx With Option 5Xx - Bering 3000 Series User Manual

2.3.1 Model 30xx with Option 5xx
2-3
GETIING READY
1. Setup the address at each HP-IB port of the disk subsystem.
Refer to Section 2.5.1 for detail. If both ports are connected
to the same computer, ensure that there is no conflict in the
address settings. WITH OPTION 531, PORT 2 AND PORT 3 SHOUlD NOT
BE CONNECTED TOGETHER.
2. Select and set partition type at each port.
2.1. WITHOUT OPTION 660: Select the partition type to define
the storage capacity for each port. Partition type can be
different at each port, but ensure that the total
assigned capacity does not exceed the maximum capacity of
the Winchester disk. Consult Tables 2.4 and 2.5 for
selection and guidance.
2.2. WITH OPTION 660: Consult Appendix G before assigning
storage capacity at each port. Partition type of each
port and the Shared Information Space has to be the same.
Also consult Tables 2.4 and 2.5 for additional guidance.
Use the following table to plan the storage capacity at each
port.
Port 1 Port 2 Port 3 Opt. 660 (SIS)
Capacity Assigned
Available Winchester Capacity: Total Capacity Assigned:
Example: A Model 3015 with Option 521. Assume Port 1 is set to
address 2, and partition type 7 (Option 210); Port 2 is set to
address 4, and partition type 6 (Option 205). The settings of
the configuration switches are shown in Figure 2.1.