Hp Series 100 - Bering 3000 Series User Manual

3.3 HP Series 100
3-9
GETTING STARTED
HP Series 100 includes HP120, HP12S, and HP1S0 computers.
3.3.1 HP150
In order to install the Winchester drive, a floppy drive is needed.
For Model 30xx, an external floppy drive like HP 9121x is required to
boot the Operating System. Make sure the HP-IB address for the floppy
drive is 0 and the Winchester drive is 2.
1. Insert the diskette labeled SYS_MASTER into the floppy drive.
2. Turn on the computer to boot or touch Re-Read Disk key to show
all available applications.
3. Select Format application and Execute.
4. Select Copy System key.
5. Select drive C (Winchester), and enter label.
6. Start formatting to initialize drive C and copy the system
software onto the Winchester.
7. Exit Format.
8. Select Device_Config and Execute.
9. The defaulted disk configuration is:
Drive HP-IB Addr. Unit
A
B
C
o
o
2
o
1
o
In order to boot from the Winchester, changes have to be made in
the configuration table to accomodate the Winchester drive. Depending
on the number of units under the selected partition type, the Winchester
drive may be configured as Drive A to 0, and unit 0 to 3. The HP-IB
address of the Winchester should be set to 0, and that of the floppy