Advertisement
TO BUBBLER
12
TO BOTTLE
FILLER
30
Figure 2 - EZLMSN-EDFPVM214DK Tube Routing
TO BUBBLER
12
30
TO BOTTLE
FILLER
21
FILTER
ASSEMBLY
Figure 3 - LZLMSN-EDFPVM214DK Tube Routing
EZLMSN-EDFPVM214DK
14
25
13
WATER
INLET
24
12
WATER
INLET
LZLMSN-EDFPVM214DK
REQUIRED TOOLS AND MATERIALS
These tables show special tools and/or additional materials
(not provided) which are necessary to complete installation
of these units:
Special Tools
Item
Additional Materials Not Included
Item
1
Unplated copper inlet pipe
2
Service Stop/Shut-off Valve
3
90° 1-1/4" Drain Line
4
1-1/4" Tee Drain Line
1. Make water supply connections (Fig. 11). Install a shut-off
valve and union connection to building water supply (valve
and union not provided). Turn on water supply and flush
the line thoroughly.
Caution: DO NOT SOLDER tubes inserted into the
strainer or filter head as damage to the o-rings may result.
2. Install mounting frame (instructions supplied with mounting
frame.
3. (For EZLMSN-EDFPVM214DK) Install 3/8" tee, poly tubing and
strainer per (Fig. 2).
(For LZLMSN-EDFPVM214DK) Access to the interior of the
unit is necessary for filter mounting and changing. Filter
mounting location is open to installer's discretion.
Recommended location to be within 18" of service stop (not
supplied).
Install the filter head to the bracket then install filter bracket to
appropriate surface near fountain. Next install a 1/4" elbow to
filter head outlet.
3a. Install the supplied 4" poly tubing and armaflex to the
previously installed elbow. Connect supplied 1/4" x 1/4" x 3/8"
tee to the 4" poly tubing. With the back panel standing close to
the frame, connect 3/8" poly tube coming from the bottle filler to
the tee per (Fig. 3).
4. Install supplied 4" poly tubing and armaflex to the outlet of the
previously installed tee or strainer. Connect supplied ¼ x ¼ x ¼ tee
to the 4" poly tubing.
5. Hang main panel on mounting frame hanger. Make sure the poly
tube do not get pinched between the panel & mounting frame.
Ensure the panel engages at the top. Align fountain holes with
mounting frame holes.
6. Remove protective coating from main panel.
7. Installing water Dispenser Place the unit into the stainless
panel and frame. Align the holes in the water dispenser with the
nuts in the panel. Attach the dispens-er to the panel using four (4)
supplied 1/4 x 20 screws.
Page 3
Description
Quantity
NONE
Quantity
Description
1
1
1
1
Advertisement
