Table of Contents
Advertisement
INPUTS
HARD SYNC
Accepts +/–5 volts. Uses the incoming signal
to reset the phase of the oscillator. This input
will work best with pulses. It can use either
positive pulses, negative pulses, or bi-polar
pulses. The positive pulses and negative pulse
will reset the oscillator to different points in
its phase. Using bipolar pulses will alternate
between resetting the oscillator to the two
different phases. Incoming pulses will force
the oscillation period to be tuned to integral
multiples of the incoming signal.
SOFT SYNC
Accepts +/–5 volts. Positive pulses at this input
will cause the upper peak of the waveform to
prematurely change direction, while negative
pulses will cause the lower peak to prematurely
change direction.
SYNC TRACKING IS HIGHLY DEPENDENT ON
THE CHARACTERISTICS AND FREQUENCY
OF THE INCOMING SIGNAL, AS WELL AS THE
FREQUENCY OF THE WAVE TRANSFORMER.
Advertisement
Table of Contents
