Download Print this page

EarthQuaker Devices Afterneath Operation Manual

Hide thumbs Also See for Afterneath:

Download this manual

Enlarged version

<<< Switching >>>

This device is true bypass and uses electronic relay based switching. Audio will not pass

without power.

<<< Power Requirements >>>

• Current Draw: 74mA

• This device take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We

always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple

isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power.

Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter

dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

<<< Tech Specs >>>

• Input Impedance: 1M Ohm

<<< Warranty >>>

This device has a limited lifetime warranty. If it breaks, we will fix it. Should you encounter any

issues, please email info@earthquakerdevices.com.

www.earthquakerdevices.com

• Output Impedance: 500 Ohm

O P E R A T I O N M A N U A L

Need help?

Do you have a question about the Afterneath and is the answer not in the manual?

Page 1 This device has a limited lifetime warranty. If it breaks, we will fix it. Should you encounter any issues, please email info@earthquakerdevices.com. www.earthquakerdevices.com O P E R A T I O N M A N U A L ©2018 EarthQuaker Devices LLC...
Page 2 Finally, the “Mix” spell alters the alchemical balance between the input signal and the effect. The Afterneath does not go fully wet, but does lower the level of the input signal as you raise this control to create the appearance of a fully wet reverb.