Klarstein CONTEMPO Manual page 31

Wall mounting
• For wall mounting, drill two 10 mm (538 mm) diameter holes with the vent
hole on the top of the hood in the centre (see illustration on next page). Make
sure the extractor hood is aligned directly over the hob.
• Insert two plastic dowels (supplied) into the holes.
• Insert two screws into the top two plastic dowels and tighten them so that
they protrude 3 mm from the wall.
• Install the extractor hood onto the two screws and mark the two bottom
screw positions.
• Remove the hood, drill the bottom two screw holes and insert the plastic
anchors.
• Install the hood on the top screws, insert the bottom screws and tighten all
screws securely.
4 screws
ST5*49
EN
31