Using The Metronome - Korg TM-70T Owner's Manual

Using the metronome

Setting the tempo and beat
1.
Press the
2.
To select pendulum (pendulum of a mechanical met-
ronome) steps or full steps, press + and − on the
button at the same time for about one second.
The default setting is pendulum steps.
• If pendulum steps is selected,
appears on the display.
• If full steps is selected, appears on
the display.
This setting is stored in memory even
when you turn off the power.
3.
To set the tempo, press + and − on the
The display indicates the numerical
tempo value.
• With pendulum steps, when you
press the
up or down as shown below. This works the same as a
mechanical metronome.
30 n 32 n 34 ... 88 n 92 n 96 ... 232 n 240 n 252 n 30 ...
Long-press the button to increase or decrease the
value continuously.
• With full steps, the tempo increases or decreases
one beat per minute at a time when you press the
button, through the range of 30 to 252.
Long-press the button to increase or decrease the
value continuously.
You can also specify the tempo using the
See "Setting the tempo via tap tempo" (p. 7) for
details.
4.
Press the
The metronome pendulum swings from left to right
in time with the tempo, and the
the tempo.
5.
To change the beat, press ,
The beat changes as follows.
0 n 1 ... 9 (9 beats) n
center beats)n
without the center beat) n
n 0 ...
6.
To stop the metronome, press the
button to turn the metronome on.
appears on the display.
button, the tempo goes
button to start the metronome.
(quadruplet) n
button blinks with
on the
(quadruplet without the
(triplets) n
6
1
2, 3
5
4, 6
button.
button.
button.
(triplets
(duplet)
button.