Table of Contents
Advertisement
7. Read the load recorded by the upper O-ring on
the tensiometer.
Typical - Load Reading
1
CM
2
3
4
5
6
O
Upper O-ring
1
8. The load reading must be as per the track deflec-
tion in the Technical Specifications.
9. If the load reading is not in accordance with the
specification, adjust the track tension. Refer to
Track Tension Adjustment.
Adjusting the Track Tension
1. Remove the tether cord cap from the vehicle cut-
2
4
6
8
10
12
14
your legs. Do not attempt to lift the rear of vehicle if
1
2. Remove the wheel caps.
3. Loosen the rear axle screw or, on 2 idler wheel
4. Tighten or loosen both adjustment screws
LYNX ADVENTURE ELECTRIC
off switch.
CAUTION
Use proper lifting techniques, including lifting with
it is above your limits.
models, the rear axle nut.
(equally) to increase or decrease track tension.
179
Advertisement
Table of Contents
