Zimmer GEP2006IO-12-B-01 Installation And Operating Instructions Manual
Hide thumbs
Also See for GEP2006IO-12-B-01:
Related Manuals for Zimmer GEP2006IO-12-B-01
Summary of Contents for Zimmer GEP2006IO-12-B-01
- Page 1 INSTALLATION AND OPERATING INSTRUCTIONS 2-jaw parallel gripper electric, robot-specific GEP2006IO-12-B-01 GEP2010IO-12-B-01 GEP2013IO-12-B-01 GEP2016IO-12-B-01 DDOC01113-01 THE KNOW-HOW FACTORY www.zimmer-group.com...
- Page 2 Depending on the application, this can be the end position or the work position. Workpiece loss Function which, in case of workpiece loss, causes the product to move to the end position. detection Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com...
-
Page 3: Table Of Contents
Product description ................................7 Functional description ................................7 Installing the product ................................7 Installing the energy supply ......................................7 Installing the wiring ........................................8 Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com... -
Page 4: Supporting Documents
This category contains useful tips for handling the product efficiently. Failure to observe these tips will not result in damage to the product. This information does not include any information relevant to health or workplace safety. Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com... -
Page 5: Safety Notices
• Use of the product under extreme conditions, such as aggressive fluids or abrasive dusts • Additional drilled holes or threads Ö Zimmer GmbH shall accept no liability for any damage caused by improper use. The operator bears sole responsibility. -
Page 6: Proper Use
► Operate the product only when it is in a technical condition that corresponds to the guaranteed parameters and operating conditions. Ö Zimmer GmbH shall accept no liability for any damage caused by improper use. The operator bears sole responsibility. -
Page 7: Product Description
Ö Damage to the contacts can result in malfunction of the product. ► Connect the power supply cable to the control system of the product. Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com... -
Page 8: Installing The Wiring
► Connect the product to the voltage supply. ► Ensure the proper voltage supply. • A voltage supply between pin 5 and pin 8 is necessary for operation. Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com... - Page 9 ► Reset the corresponding signal after the movement is complete. The signal must be reset before a signal is emitted in the opposite direction. ► Observe a break time of 10 ms between the reset of the signal and the next command. Zimmer GmbH • Im Salmenkopf 5 • 77866 Rheinau, Germany • +49 7844 9138 0 • www.zimmer-group.com...
Need help?
Do you have a question about the GEP2006IO-12-B-01 and is the answer not in the manual?
Questions and answers