Installing The Led Assembly - Hinkley SWELL Instruction Manual

INSTALLING THE LED ASSEMBLY

Adapter
plate
Fig. 1
NOTE: Before starting installation, disconnect the power by
turning o° the circuit breaker or removing the fuse at fuse
box. Turning power o° using the fan switch is not suÿcient
to prevent electric shock.
If you do not wish to install the light kit, skip this
step and proceed to next step.
1 Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Place the key holes on the adapter plate over the 2 screws
2
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the adapter plate
3
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
Mounting hub
(bottom of motor)
Screws
5
Wire connectors
Light kit
Glass shade
Fig. 2
4 While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- White to white
- Black to blue
Tuck connections neatly into adapter plate. Place the key
5
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
Raise the glass shade or metal cover against the LED light kit
6
and turn clockwise until snug,
Restore power and your light kit is ready for operation.
7
Adapter plate
Screws
DO NOT OVERTIGHTEN.
| hinkley.com |
©2023 Hinkley Lighting, Inc.
11